Stainless Steel HD-10
60 Cubic Feet Mixing Capacity or 3,000 Pounds Per Batch.
Equipped with Center Discharge Agitator, Shaft Mounted Speed Reducer and Legs.  All contact points are stainless steel.

If the product you mix is for human consumption, Stainless Steel should be used for all contact points.   This is where the ingredients being mixed come in contact with the mixer.  Optionally, all welds inside the mixer can be ground smooth.  Oftentimes, Stainless Steel Construction is required for mixing certain veterinary products and when handling items that have a harmful corrosive or acidic effect on mild steel.

Stainless Steel Model HD-30
Mixing Capacity 115 Cubic Feel or 5,750 Pounds Per Batch

STAINLESS STEEL CENTER DISCHARGE RIBBON AGITATOR

The two outer ribbons bring material to the center of mixer's tank while the inside ribbons move ingredients back to each end.

BUILT TO FIT YOUR JOB.  NOT JUST TO SELL!

STAINLESS STEEL SAWTOOTH PADDLE AGITATOR

This agitator is very similar to our paddle agitator except for one basic difference.  The agitator's forward paddles have notches or saw teeth cut in them to prevent a pinch point from occurring between the paddles and the bottom of the mixer's tank.  These serrations relieve the strain on both tank and agitator, which could occur when a high percentage of non-free-flowing materials is being mixed.

Sawteeth not only cut down the pinch point between paddle and tank, which makes handling these items easier, they also provide a much gentler mixing action which prevents unnecessary damage to these valuable ingredients.  In this way the integrity of the mix is maintained and protected.  The agitator's reversing paddles are attached to posts which are shorter.  This provides mixing action in the center of the agitator, which is absolutely necessary to blend rations that contain high percentages of ingredients that are not free-flowing.

Questions, Comments about any of our products, please let us know!

---